Tinker CAD Lesson 5

Lesson 5:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To make this crown I first had to bring a hemi-sphere onto the grid. Then I had to get one of the thin tubes and cut them in half by using a square and placing it half way through the tbe, then I hade the square a hole and grouped everything. When i had finished making the tube small enough I even placed it all aroung the hemi-sphere. After that I made the cylinder small and flattened it, after that I put it onto the hemi-sphere as well. For the round tube at the bottom I moved the thin tube onto the bttom of the Hemi-sphere. Finally I got a cone and placed it onto the top of the hemi-sphere. To add the finishing touches I coloured everything as shown in the picture and aliend anything that was remaining.

To me I found this very easy as I already knew hov to make all the pieces, the only thing that took me time was making everything well aligned. as in all of the other designs the shapes looked very well fitted from the front but when I rotated the gid to see how everything looked from the back it was a little disapoingting. But as I learnt how to fix that problem fast because of the practice on the other designs it became easier.